上海摩托车英文科目一

1. Gun powder, explosives and detonating powder belong to which of the following dangerous chemicals?

A. Oxidizing materials

B. Inflammable solid materials

C. Explosives

D. Self-igniting articles

Answer: C

2. A driver should accelerate in advance to overtake then it is likely to meet with oncoming vehicles.

A. Right

B. Wrong

Answer: B

3. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

4. When encountering a vehicle in front ascending on a mountainous road covered with ice and snow, what should the motor vehicle driver do?

A. Ascend after the vehicle in front passes the slope

B. Overtake the vehicle in front swiftly and drive on

C. Overtake the vehicle in front with a slow speed and drive on

D. Follow the vehicle in front closely

Answer: A

5. When a motor vehicle reaches a muddy or burst-and-muddy section of the road, the driver should stop, observe and select a level and solid section or a section with vehicle tracks.

A. Right

B. Wrong

Answer: A

6. When a motor vehicle temporarily stops at night, which lamp should be turned on?

A. Front and rear fog lamp, clearance lamp and rear position lamp

B. Head lamp, clearance lamp and rear position lamp

C. Hazard lamp, clearance lamp and rear position lamp

D. Reverse lamp, clearance lamp and rear position lamp

Answer: C

7. When driving on a long downhill road, which is the best way to control the speed?

A. Coast in neutral gear

B. Take a low gear

C. Depress the clutch

D. Pull up the handbrake

Answer: B

8. When driving on a road covered with ice and snow, the motor vehicle may spin or slide when increasing the speed urgently, due to the loss of vehicle stability.

A. Right

B. Wrong

Answer: A

9. When rescuing a wounded person in coma, it is necessary to take warm-keeping measures to prevent heat loss.

A. Right

B. Wrong

Answer: A

10. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D